Fuses And Light Bulbs; Fuses - Skoda Yeti Owner's Manual

Fuses and light bulbs

Fuses

ä
Introduction
This chapter contains information on the following subjects:
Fuses in the dash panel
Fuses in the engine compartment
Individual electrical circuits are protected by fuses.
›
Before replacing a fuse, switch off the ignition and the appropriate consumer
›
Find out which fuse belongs to the component that is not operat-
ing » page 207, Fuses in the dash panel or
compartment.
›
Take the plastic clip out of its fixture in the cover of the fuse box, place it on the
relevant fuse and pull it out.
›
A blown fuses is recognisable by the molten metal strip. Replace the faulty fuse
with a new one of the same amperage.
Colour coding of fuses
Colour
light brown
dark brown
red
blue
yellow
white
green
orange
red
WARNING
Always read and observe the warnings before completing any work in the en-
gine compartment » page 175, Engine compartment.
206
Do-it-yourself
207
208
» page 208, Fuses in the engine
Maximum amperage
5
7,5
10
15
20
25
30
40
50
CAUTION
Never "repair" fuses and also do not replace them with a fuse of a higher am-
■
perage - risk of fire! This may also cause damage at another part of the electrical
system.
Have the electrical system checked as quickly as possible by a specialist garage
■
if a newly inserted fuse blows again after a short time.
When unlocking and locking the cover for the fuse box in the engine compart-
■
ment, it must be pressed on the sides of the box, otherwise the locking mecha-
nism can be damaged.
The cover for the fuse box in the engine compartment must always be applied
■
correctly. Water can penetrate and cause damage to the vehicle if the cover was
not applied correctly!
Note
We recommend always carrying replacement fuses in the vehicle. A box of re-
■
placement fuses can be purchased from ŠKODA Original Accessories.
Multiple fuses may exist for a single power consuming device.
■
Multiple power consuming devices can share a single fuse.
■
Electrically adjustable seats are protected by automatic circuit breakers, which
■
switch on again automatically after a few seconds after the overload has been
eliminated.
