Fitting The Mechanical And Digital Time Clocks - Ariston C Operating Instructions Manual

13. Electrical Connections
13.1

Fitting the Mechanical and Digital Time Clocks

To fit the integral time clock it is necessary to proceed as follows;
(this should only be carried out by a competent engineer)
- Isolate the electical supply to the appliance;
- Remove the front panel as described in Section 18.1.1;
- Remove the plastic cover on the right hand side (Fig. 34)
and pull out the 4 wires (Fig. 35);
N : T
OTE HE WIRES MAY BE TUCKED BEHIND THE ELECTRICAL COVER
- Connect the time clock wires as follows;
M M (Fig. 36)
ECHANICAL ODEL
Red Wire - Contact 1
Black Wire - Contact 2
Black Wire - Contact 3
Grey Wire - Contact 5
N : T
OTE HE TWO BLACK WIRES ON
D M (Fig. 37)
IGITAL ODEL
Red Wire - Contact 1
Black Wire - Contact 2
Grey Wire - Contact 3
N : S B W
OTE ECOND LACK IRE IS NOT CONNECTED
- Push the clock back into the panel and refit the casing
panel (Fig. 38).
Fig. 36
5 4 3
G
C 2 & 3
ONTACTS CAN BE REVERSED
.
2 1
R
B
Fig. 38
(continued)
.
Fig. 34
Fig. 35
Fig. 37
29