Bosch CM12 Operating/Safety Instructions Manual page 29

BM 2610021316 10-11 E:BM 2610021316 10-11 E.qxp 10/17/11 11:02 AM Page 29
Miter and Bevel Settings for Standard Crown Molding Cuts
Assumptions: Molding is milled consistently. Corner is exactly 90º.
Molding Spring Angle is 38 degrees
Inside Corner
Left end (A)
Use the left end
of the cut
Right end (B)
Use the right end
of the cut
Outside Corner
Left end (C)
Use the left end
of the cut
Right end (D)
Use the right end
of the cut
Ceiling
52°
Wall
38°
38/52° Crown Molding
38° Spring Angle
(When Crown Molding is lying flat on Table)
Miter Bevel
(Table) (Tilt)
Setting Setting
(31.6) Right (33.9) Left
(31.6) Left (33.9) Right
(31.6) Left (33.9) Right
(31.6) Right (33.9) Left
Ceiling
45°
45° Wall
45/45° Crown Molding
45° Spring Angle
Fence
Molding Spring Angle is 45 degrees
Inside Corner
Left end (A)
Use the left end
of the cut
Right end (B)
Use the right end
of the cut
Outside Corner
Left end (C)
Use the left end
of the cut
Right end (D)
Use the right end
of the cut
Inside
Corner
Top of Molding
Against Fence
Table
-29-
Miter Bevel
(Table) (Tilt)
Setting Setting
(35.3) Right (30.0) Left
(35.3) Left (30.0) Right
(35.3) Left (30.0) Right
(35.3) Right (30.0) Left
Outside
Corner