Panasonic CS-V18DKE Service Manual page 29

Note: The illustrations in this manual are for explanation purposes only and may differ from the
actual unit. It is subjected to change without notice for future improvement.
PRODUCT OVERVIEW
I ndoor Unit I ndoor Unit
Front panel
Air filter
Airflow direction
louver
Discharged air
Outdoor Unit Outdoor Unit
Air inlet (rear)
Air inlet
(side)
Remote Control Remote Control
LCD display
Ion operation
Operation mode
Airflow direction
adjustment
Memory reset
Troubleshooting
G Operation delayed for few minutes after restart.
G Sound like water fl owing during operation.
G Mist emerges from indoor unit.
G Noisy during operations.
G Remote control/display does not work.
G The unit cannot operate.
G Outdoor unit emits water/steam.
Air intake
Ionizer
Indicator
Do not touch
during operation
POWER TIMER QUIET POWERFUL ION
Air outlet
Transmitter
Temperature setting
Off/On
Quiet operation
Powerful operation
Fan speed selection
Timer setting
Clock setting
➤
This is a normal self protection control.
➤
Caused by refrigerant fl ow inside.
➤
Condensation effect due to cooling process.
➤
Installation work could be slanted or front panel didn't close properly.
➤
Check whether batteries are correctly inserted or need replacement.
➤
Check either circuit breaker is tripped, power plug is inserted correctly or
timer is used correctly.
➤
Condensation or evaporation happens at piping surface.
29
I About
Remote Control Preparation
Supersonic air
purifying device
Auto OFF/ON 1. Pull out
button
Receiver
3. Press CLOCK button
5. Press again to confi rm
• Timer operation will be based on
current time set.
• The batteries can be used for
approximately 1 year.
• The batteries must be
SUPER
ALLERU-BUSTER
recycled or disposed of
properly.
Remote Control Signal
• Make sure it is not obstructed.
• Maximum distances: 10m.
• Certain fluorescent lights may
interfere with signal transmission.
Consult your dealer.
Auto OFF/ON Button
• To operate the unit if the
remote control is misplaced or
malfunctioning.
Press once
Press until "beep"
• To OFF, press again the Auto OFF/
ON button.
• To switch the remote control signal
receiving sound off or on.
1. Press until "beep" sound and
release.
2. Press again until "beep-beep"
sound and release.
3. Press to switch the sound off or
on.
(Long "beep" - OFF; short "beep"
- ON)
CS-V18DKE CU-V18DKE / CS-V24DKE CU-V24DKE
2. Insert
batteries
(AAA or
R03)
4. Set
current
time
Operation
Action
mode
Automatic
Operation
Cooling
sound Operation