Inspection - Suzuki LT-Z90K7 2007 Service Manual

6-8 ELECTRICAL SYSTEM
Step 5
1) Measure the generator no-load performance. (
Is the generator no-load performance OK?
YES Go to Step 6.
NO Faulty generator.
Step 6
1) Inspect the regulator/rectifier. (
Is the regulator/rectifier OK?
YES Go to Step 7.
NO Faulty regulator/rectifier.
Step 7
1) Inspect wiring harness.
Is the wiring harness OK?
YES Faulty battery.
• Short circuit of wiring harness.
NO
• Poor contact of couplers.
Battery overcharges
• Faulty regulator/rectifier.
• Faulty battery.
• Poor contact of regulator/rectifier lead wire coupler.

INSPECTION

BATTERY CURRENT LEAKAGE
• Remove the seat. (
• Turn the ignition switch to the OFF position.
• Disconnect the battery - lead wire.
• Measure the current between - battery terminal and the -
battery lead wire using the multi-circuit tester. If the reading
exceeds the specified value, leakage is evident.
09900-25008: Multi-circuit tester set
Tester knob indication: Current (
Battery current (leak): Under 1 mA
* In case of a large current leak, turn the tester to high
range first to avoid tester damage.
* Do not turn the ignition switch to the "ON" position
when measuring current.
NOTE:
When checking to find the excessive current leakage, remove
the couplers and connectors, one by one, checking each part.
6-10)
5-4)
, 20 mA)
6-10)