Hls Ps25 And Hls Ps50 Characteristics - Honeywell HLSPS25-XPH User Manual

HLS PS25 & HLS PS50 User Manual
2.1 HLS PS25 / HLS PS50 characteristics
These Po wer Supplies Units are des igned to comply with th e
requirements of EN54-4 in order to provide fire control systems with
backup supply.
The HLS PS Series operates at 115/230 Vac and 50/60 Hz.
Both Power Supply Units, HLS PS25 a nd HLS PS50, a re very similar :
they consist o f a 2x 65W, which means 1 30W in HL S PS50 and 1 x65W
in HLS PS25 and a standard module control which supervises the entire
power supply.
HLS PS25 an d HLS PS50 power supplie s provide 2.5 Amp and 5 Amp
respectively a nd 300mA to 600mA of th em are dedic ated to charg e
batteries. Th ese po wer su pplies are able to supply either up to 1.1 0
and 2.20 Amp current at each PSO1 a nd PSO2 out puts. This is the
default set up (DIP SW1 ON, up position). However, power supplies can
also supply all the current in only one outp ut by placing the DIP SW1 in
the down position, OFF. This way, all the current (2.20Amp or 4.40Amp
respectively) will be supplied through PSO1 output.
HLS PS25
SW1 up
SW1 down
HLS PS50
SW1 up
SW1 down
8
MN-DT-1305I_B