Specification - Honeywell HLSPS25-XPH User Manual

Specification

3.
Dimensions:
Power Supply Wattage:
Input Voltage:
Output voltage:
Power Supply Outputs:
Terminals:
Optional conversion 2 outputs to 1 output:
Maximum current per output*:
Maximum current using only one output
Alarm input:
Battery load current:
Fault relay:
State Indicators:
Battery room:
Conduit knockouts:
Earth Fault Supervision:
Standards:
Vibration test:
NOTE: Shield cables are required for power supply units' connection.
MN-DT-1305I_B
377 mm (w) x 408 mm (h) x 92 mm (d).
130 W (HLSPS50) y 65 W (HLSPS25).
The HLSPS50 power supply has a total of 5Amp and 300mA
to 600mA of them are dedicated to charge batteries.
115 - 230 Vac; 50/60 Hz
28 VDC +/-2% VDC (overload and short circuit protection).
2
Removable terminals for 2.5 mm cable.
Yes, using DIP SW1.
1.10 Amp (HLSPS25); 2.20 Amp (HLSPS50).
2.20 Amp (HLSPS25); 4.40 Amp (HLSPS50).
By linking bo th terminal s with a jumpe r (or short-circuit), this
input allo ws the battery charger momentary di sablement in
order to provide extra 300/600 mA to the outputs.
300 mA (7 Amp/hour) / 600 mA (17 Amp/hour).
80% of the Battery Capacity is charged in less than 24 h and
the 100% in less than 48 h.
C, NC, NO contacts. 1 Amp/24Vdc maximum.
Energized in normal state.
10 external leds (5 mm) + 7 internal (SMD).
For 2 x 22 Amp/hour
Ø 21 mm 6 at the top of the back box
6 at the rear top of the back box
Configurable (ON/OFF)
Design according to EN5 4-4; UL19 50; TUV EN6 0950 a nd
EMC standards, EN55022, IEC1000-4-2,3,4,5 IEC1000-3-2.
10-500 Hz 2G 10 min/1 cycle during 60 min. on each axle.
HLS PS25 & HLS PS50 User Manual
14