Table of Contents
Advertisement
MN-DT-1305I_B
1.2 Pre-installation check list
Before selecting the location for the HLS PS Series, DO make
sure that:
a) The ambient temperature is in the range:
-5 ºC to 40 ºC
b) The relative humidity is bellow:
93%
(non-condensing)
c) DO NOT loca te th e e quipment w here i t is ex posed to high
levels of moisture.
d) DO NO T locate the e quipment where there ar e hi gh levels of
vibration or shock.
e) DO NOT s ite the HLS PS Series where there w ould be
restricted access
to the
connections.
1.3
Transient protection
As with all solid state devices, this system may operate erratically
or c an be damaged i f sub jected to li ghtning-induced t ransients.
This equipmen t contains trans ient p rotection devic es. Al though
no sys tem is immune from l ightning transients an d in terference,
for thes e devices to func tion co rrectly, and to reduc e
susceptibility, this equipment must be earthed correctly.
The use of overhead or outside aerial wiring is not recommended
due to the increased susceptibility to nearby lightning strikes.
The HLS PS Series is wall m ounted in a posi tion, which a llows
clear v isibility of ind icator leds. The he ight above fl oor le vel
should be chosen such that t he indicators are just above normal
eye level (approximately 1.5 metres).
1.4
Cleaning
The HLS PS Series cas e may be clean ed periodically by wiping
with a soft, damp lint-free cloth.
Do not use solvents.
HLS PS25 & HLS PS50 User Manual
internal equ ipment and
wiring
5
Hide quick links:
Advertisement
Table of Contents
