Canon DADF-Q1 Service Manual page 54

Chapter 2
Pickup/Separation.')
2) The machine rotates the registration roller and the transport belt to move the 1st original.
3) When the lead edge of the 1st original has moved past the post-registration roller sensor (S3) and has been moved over a specific distance by the transport belt,
the machine stops the original (standby position). (At this time, the machine starts to keep track of the distance over which the 1st original moves after it has
moved past the pre-registration roller paper sensor (S2).)
4) The machine rotates the transport belt to move the original over a specific distance, and discharges it (reading takes place here).
5) When the 1st original has fully been discharged, the machine starts pickup of the 2nd original.
6) The machine goes back to step 2. and repeats the subsequent steps.
2-32
Registration roller
Registration roller
Pre-registration roller paper sensor(S2)
Post-registration roller
paper sensor(S3)
2nd original
2nd original
1st original
F-2-61
2nd original
Transport belt
F-2-62
Standby position
F-2-63
F-2-64
F-2-65