Canon DADF-Q1 Service Manual page 101

[1]
6) Remove the grip ring [1] on the front side plate side, and pull out the clutch
ring [2].
7) Remove the screw [2] of the gear support plate (front) [1]; then, shift the
gear support plate (front) [10] to the left to pull out the clutch [3] to the
front. The clutch has two stoppers. Use the white stopper when re-assm-
bling.
[2]
8) Disconnect the two connectors [1], and remove the two mounting screws
[2]; then, detach the separation unit [3].
[2]
F-3-157
[1] [2]
F-3-158
[1]
[3]
F-3-159
[1] [2]
[3]
F-3-160
9) Remove the E-ring [1], and pull out the shaft [2].
[1]
10) Remove the grip ring [1] at the front, and remove the bushing [2].
[2]
11) Remove the E-ring [21] and the bushing [2] at the rear, and detach the
rod arm plate [3].
[3]
12) Remove the E-ring [1] and the one-way gear [2].
Chapter 3
[3] [2]
F-3-161
[2]
F-3-162
[1]
F-3-163
[2]
[1]
F-3-164
3-23