Canon DADF-Q1 Service Manual page 130

Chapter 4
mm.
Then, close the DADF slowly.
Original
D
6) To adjust the original stop position, use the push switches SW3 and SW4
on the ADF controller PCB.
A single press on each switch will shift the original stop position by a dis-
tance of 0.5 mm. When the correct stop position is attained, press the push
switch (SW2).
- The original will be delivered, and the new position will be stored in
memory.
J16 J15
J1
J2
J4
CB1
SW1
J5
DSP1
SW4SW3SW2
J3
J6
Switch Direction of shift
SW3 Right
SW4 Left
Original
SW4 SW3
Holding down on the push switch will not cause more than a single shift.
EX
If the copy paper is stopped 12 mm from the copyboard glass,
Close the DADF slowly leaving the copy paper on the copyboard glass.
To shift the stop position 1 mm to the left, the following is true:
1 0.5 (adjustment interval) = 2
Hence, press the push switch SW4 twice, and then press the push switch
SW2.
- The copy paper will be delivered, and the new setting will be stored in
memory.
4-20
D=11±1mm
F-4-97
J14
J13
J12
IC8
J7 J8 J9 J10 J11
F-4-98
T-4-7
F-4-99
b. Pickup from the Manual Feed Tray
1) Remove the screw [1], and detach the ADF controller cover [2].
2) Set the DIP switch (SW1) on the ADF controller PCB as indicated.
3) Open the manual feed tray, and place a single sheet of A4 or LTR copy
paper.
- Be sure to butt the copy paper against the rear.
Manual feed tray
4) Press the push switch (SW2) on the ADF controller PCB once.
- A single press on the push switch (SW2) causes the original to be picked
up and stopped on the copyboard glass.
J16 J15
J1
J2
J4
CB1
SW1
J5
DSP1
SW4SW3SW2
J3
J6
5) Open the DADF slowly, and check to make sure that D indicated is 11±1
mm.
Close the DADF slowly.
Original
D
6) To adjust the original stop position, use the push switches SW3 and SW4
on the ADF controller PCB.
[2]
[1]
F-4-100
F-4-101
Butted.
Copy paper
F-4-102
J14
J13
J12
IC8
J7 J8 J9 J10 J11
F-4-103
D=11±1mm
F-4-104