SECTION 2: INSTALLATION AND SETUP
PROCESS ON THE SCREEN FOR VOLTAGE INDICATION OF CARD BACKUP
MEMORY
T E S T P R I N T
1
[
]
←
B A T T E R Y C H E C K
2
[
]
←
R A M B A C K B A T T E R Y
3
[
]
←
C A R D B A T T E R Y
4
[PGUP]
C A R D B A T T E R Y
B A T T E R Y F U L L
Note: Where card is not connected, there can not be seen any descriptions in the second line. For Service
Maintenance Mode, FULL/EMPTY can be made available for the voltage indication of card back-up
memory. The voltage can not be displayed. Whether the voltage is FULL or EMPTY will become available
for the back-up memory when power is applied.
Page 2-32
9 + Power "ON"
Press [ENTR], so that it starts test print.
Press [
], so that it goes to the process No. 2.
→
[
]
→
Press [ENTR], so that it displays voltage in battery.
Press [
], so that it returns to the process No. 1.
←
Press [
] , so that it goes to the process No. 3.
→
[
]
→
Press [ENTR], so that battery level (or remaining
fuel) can be indicated for RAM's back-up.
Press [
], so that it returns to the process No. 2.
←
Press [
], so that it goes to the process No. 4.
[
]
→
→
Press [ENTR], so that battery level (or remaining
fuel) can be indicated for card's back-up.
Press [
], so that it returns to the process No. 3.
←
[ENTR]
Press [PGUP], so that it returns to the screen for the
selection of battery level indication for cards
back-up.
SATO HT200e