Sequencer P3: Midi Filter; 3-1: Midi; 3-2: Midi 1 9-16 - Korg TRITON Extreme Manual

Scale:
Specifies the scale that will be used for the song.
Type (Song's Scale)
[Equal Temperament...User Octave Scale15]
Selects the type of scale (☞"Type" Program P1: 1–1c).
Key
Selects the tonic key of the selected scale (☞"Key" Program
P1: 1–1c).
Random
As this value is increased, an increasingly random devia-
tion will be added to the pitch at each note-on (☞"Random"
Program P1: 1–1c).
74

Sequencer P3: MIDI Filter

Here you can select whether or not to apply filtering to the
MIDI data received by tracks 1–16. For example even if two
tracks are receiving the same MIDI channel, one can be set to
respond to damper pedal activity while the other does not.
[C...B]
These MIDI filter settings have no effect on the MIDI
messages that have already been recorded.
These settings affect the MIDI messages that are trans-
[0...7]
mitted when you adjust program, pan, volume, porta-
mento and send 1/2 parameters of a track whose
"Status" (2–1a/2a) is set to BTH, EXT, or EX2.
On (checked): Reception of MIDI data is enabled. Tracks
whose "Status" (2–1a/2a) is INT or BTH will receive these
types of MIDI messages on their respective channels. The
type of effects that are checked will be applied to the pro-
gram of each track when the TRITON Extreme's controllers
are operated or when MIDI data is received. (The effect
dynamic modulation function is not affected by these set-
tings.) Settings that regulate MIDI transmission/reception
of the TRITON Extreme itself are made in MIDI Filter (Glo-
bal P1: 1–1b).
If the user-assignable controllers that can be filtered in the
MIDI 3 and MIDI 4 pages are set to MIDI control changes,
filtering will be performed for these control changes. In this
case, any control change filtering that is being performed in
the MIDI 1 and MIDI 2 pages will be given priority. Further-
more, if the same control change is assigned to multiple con-
trollers for which there are filter settings in the MIDI 3 and 4
pages, checking any one of these will enable that control
change.
Off (unchecked): Reception of MIDI data is disabled.
3–1: MIDI 1 1–8
3–2: MIDI 1 9–16
0–1a
0–1b
0–3a
3–1a
3–1(2)a: Enable Program Change, Enable After Touch,
Enable Damper, Enable Portamento SW
Enable Program Change
Specifies whether or not MIDI program change messages
will be received.
Enable After Touch
Specifies whether or not MIDI after touch messages will be
received.
Enable Damper
Specifies whether or not MIDI control message CC#64 Hold
(damper pedal) will be received.
(MIDI Filter –1 T01–08)
(MIDI Filter –1 T09–16)
[Off, On]
[Off, On]
[Off, On]
0–1