Troubleshooting - Panasonic Panafax UF-9000 Operating Instructions Manual

Problem Solving

Troubleshooting

Unit Does Not Operate
Does the display light?
Does the Energy Saver key flash (or light)
and the display is turned OFF?
(See page 30)
Does any of the U## codes and messages
appear on the display?
(U1, U13, U16....etc.)
Does the Add Paper indicator and message
appear on the display?
Does the message and J## Codes appear on
the display? (J00, J01, J02,...etc.)
Does E#-## codes and messages appear on
the display?
The machine would not accept the next job
during operation, instructed job would not be
accepted for a long time period or job would
not be completed.
Light Copies
Press the CONTRAST Key then check
contrast level.
Does the replacing Toner Cartridge and
message appear on the display?
56
Check Action
Check if the Power Switch (Main Power Switch
on the Left Side of the machine) is turned ON
and if the power cord is plugged into the AC
outlet.
Press Energy Saver key on the control panel.
Perform actions in accordance with each
message.
Add paper. (See page 14)
Remove the misfed paper. (See page 18)
Be sure to set paper as adjusted with paper
guides. (See page 42)
Turn the Power Switch on the Left Side of the
machine to the OFF* and ON position. If the
error code does not clear, call your Service
provider.
Turn the Power Switch on the Left Side of the
machine to the OFF* and ON position.
NOTE:
*If the Hard Disk Drive Unit (DA-HD19) is
installed, see page 13.
Press Cursor Keys to Darker.
(See page 25)
Replace the Toner Cartridge.
(See page 16)