Printer Settings (For Key Operator) - Panasonic Panafax UF-9000 Operating Instructions Manual

Function
■ Printer Settings (Continued)
No.
FONT (PCL) *
08
SYMBOL TABLE (PCL) *
09
PITCH (PCL) *
10
POINT SIZE (PCL) *
11
LINES/PAGE (PCL) *
12
RETURN CHARACTER (PCL) *
13
14 MUTUAL A4/LETTER
MAILBOX MEMORY STATUS *
15
19 KEY OPERATOR MODE
*
1
Available only when the optional Printer Controller Module is installed.
* 2
Available only when the optional Hard Disk Drive Unit is installed.
NOTE: Normally, you have no need to set the Printer Settings. When sending the text data from MS-DOS status
to the printer directly, such special printing may require Printer Settings.
The following Parameter Settings require the input of the Key Operator Password:

■ Printer Settings (For Key Operator)

No.
00 PRINTER SETTINGS
01 COMPLETION TIME
02 PAGE PROTECTION
03 ERROR PAGE PRINT
04 SPOOL FUNCTION
05 TEXT PRINT
40
Modes
1
Sets the PCL font.
0-99
1
Sets the PCL symbol table.
0-35
1
Sets the PCL pitch.
0.44-99.99
1
Sets the PCL point size.
4.00-999.75
1
Sets the PCL lines/page.
5-128
1
Sets the PCL return character.
1:CR / 2:CR+LF
Selects whether the mutual size A4/LETTER is
enabled.
1:OFF / 2:ON
2
Indicates the mailbox memory status.
Inputs the key operator password.
ENTER PASSWORD =
Modes
Prints the printer settings.
PRESS SET TO PRINT
Sets the job completion time setting.
1-999SEC (second)
Selects whether to enable automatic
compression when the received data exceeds
the page memory capacity.
(This is accomplished by reducing resolution,
and/or deleting pixels to fit the data onto the
available page memory, then print it out.)
When the setting is in the "OFF" position, upon
exceeding the page memory capacity, the print
job is deleted and an Error message is displayed.
1:OFF / 2:ON
Select whether to print the error page.
1:OFF / 2:ON
Select whether to enable the spool function.
1:OFF / 2:ON
Select whether to print the text page only.
1:OFF / 2:ON
Function
Function
Initial
Setting
0
11
10.00
12.00
60
1:CR
1:OFF
Initial
Setting
180SEC
1:OFF
2:ON
2:ON
2:ON
<to be continued>