Interrupting Operation; Finish Operation - Kärcher KB 3030B Operating Instructions Manual

Operation with detergent
Note: Detergent can only be added when
the appliance is being operated in low pres-
sure mode.
All washing brushes supplied by Kärcher are
designed for use with detergents.
Detach spray lance from spray gun.
Note: A low-pressure jet is generated if
the spray lance is not attached to the
spray gun.
Detergent take-up from container
Place the end of the detergent suction
tube in a container with Detergent solu-
tion.
Recommended Cleaning Method
1 Spray a small dose of the detergent on
the dry surface, and allow it to react
(make sure the detergent does not dry
up).
2 Wash off the loosened dirt using the
high-pressure jet.

Interrupting operation

Release the lever on the spray gun.
During breaks, use the safety catch to
secure the spray gun lever.
During longer breaks (more than 5 min-
utes), also turn the appliance off using
the ON/OFF switch.

Finish operation

If detergent has been added: Suspend
detergent suction tube in a container
filled with clear water, switch the appli-
ance on for around 1 minute once the
spray lance has been removed and rinse
until water runs clear.
Release the lever on the spray gun.
Switch the appliance switch to "0/OFF".
Turn off tap.
Press the lever on the spray gun to re-
lease any remaining pressure in the sys-
tem.
Disconnect the appliance from the water
supply.
Detach spray lance from the spray gun.
Briefly switch the appliance on ("I/ON"),
press the spray gun lever until no further
water is discharged (approx. 1 min).
Switch the appliance switch to "0/OFF".
Use the safety catch to secure the spray
gun lever.
Pull out the mains plug.
Roll up the power cord and loop it round
the power cord storage.
Storing the Appliance
Caution
Frost can destroy an incompletely emptied
unit. Store the appliance in a frost resistant
room during winter.
Unlock and retract transport handle.
Store the spray gun and the spray lances
in the accessory mount.
7
English