Maintenance And Cleaning; Environmental Protection - Bosch GWS 6-100 PROFESSIONAL Operating Instructions Manual

2 609 140 063 - Buch Seite 6 Mittwoch, 11. Februar 2004 10:03 10
Cutting
When cutting, do not press, tilt or
oscillate. Gently slide it forward with
a speed adapted to the material be-
ing worked on.
Do not brake cutting discs that are
slowing down to a stop by using
side pressure.
When cutting profiles and square pipes, it is best
to start with the smallest cross section.
Rotating the Machine Head
Before any work on the machine itself, pull
the power plug.
Unscrew the four screws completely.
Rotate the machine head carefully and without
removing it from the housing bring it to its new
position.
Screw in the screws again and tighten.
11 • 2 609 140 063 • TMS • 04.02.04
The cutting direction
is very important.
The machine must
always work opposite
to the direction of ro-
tation. Therefore,
never move the ma-
chine in the other di-
Should the machine fail in spite of careful manu-
rection! Otherwise,
facturing and testing, its repair should be carried
there is the danger of
out by a Bosch power tools authorized service
it being pushed un-
agent.
controlled out of the
cut.
For all correspondence and spare parts orders,
always include the 10-digit part number of the
machine!
The machine head
can be rotated in 90°
steps with respect to
the machine housing.
Recycle raw materials instead of disposing
By doing this, the
them as waste
On/Off switch can be
The machine, its accessories and packaging ma-
brought to a better
terials should be sorted for environmentally-
position for special
friendly recycling.
working situations,
e. g., for cutting
These instructions are printed on chlorine-free re-
work with the cutting
cycled paper.
guide/cutting grinder
The plastic components are labeled for catego-
stand (accessory) or
rized recycling.
for left-handed per-
sons.
English - 6

Maintenance and Cleaning

Before any work on the machine itself, pull
the power plug.
For safe and proper working, always keep
the machine and the ventilation slots clean.
Under extreme working conditions, con-
ductive dust can accumulate in the interior
of the machine when working with metals,
which can impair the protective insulation
of the machine.Therefore, in such cases it
is recommended that stationary dust ex-
traction equipment be used as well as the
frequent blowing out of the ventilation slots
and the installation of a residual current de-
vice (RCD).

Environmental Protection