Show Mpls Forwarding-Table - Zte ZXR10 8900 Series Command Reference Manual

Command Modes
Syntax
Syntax
Description
Instructions
Example
Related
Commands
Command
Function
Command Modes
triggered between local interface and the remote interface. Delete
the VPWS with the no form of this command. VPWS service can
be configured to use static PW.
Interface configuration
mpls xconnect [static-pw]<ip-address>[<static-p>]<vc-id>[t
unnel <tunnel number>][mtu <mtu value>]
no mpls xconnect
<ip-address>
<vc-id>
tunnel <tunnel
number>
static-pw
<mtu value>
VCID must be unique on local node and the corresponding inter-
face on remote node must have the same VCID. Network-unique
PW identifier is composed of remote node IP address and VCID.
With parameter tunnel, MPLS label is assigned by specified tunnel;
with no parameter tunnel, the label is assigned by LDP.
V4.8.22 and its later versions support to configure VPWS service
of static PW.
V4.08.23 and its later versions support to configure mtu of VPWS
service.
Establish VPWS with vcid to be 99 between interface vlan 99 and
the node whose router-id is 1.1.1.1; establish VPWS with vcid to
be 100 between interface vlan 100 and the node whose is router-id
is 1.1.1.1.
ZXR10(config#)interface vlan99
ZXR10(config-if)#mpls xconnect 1.1.1.1 99
ZXR10(config-if)#exit
ZXR10(config#)interface vlan100
ZXR10(config-if)#mpls xconnect 1.1.1.1 100 mtu 1504
Configure VPWS which uses static PW:
ZXR10(config-if)#mpls xconnect static-pw 1.1.1.1 test 100
show mpls l2transport binding

show mpls forwarding-table

This checks LIB.
All Modes
Confidential and Proprietary Information of ZTE CORPORATION
Chapter 2 MPLS LDP Configuration
IP address of the remote interface or router
identifier of the remote node
VPWS identifier, range: 1~4294967295
Tunnel number used for creating VPWS,
range: 1~1024
Configure all static PW entries of VPWS
service which use static PW.
the size of mtu, range: 12816383.
31