Troubleshooting; Specifications - JBL ON STAGE 200ID User Manual

TROUBLESHOOTING
Symptom
Possible Problem Solution
No sound from the No power to the system Ensure that the power supply is connected to a live power
JBL On Stage 200lD speaker source and is properly connected to JBL On Stage 2001D.
system Power adapter plug is not inserted correctly
(Note:When the JBL On Stage 200lD system is powered,
Le iPodliPhone est en mode Pause
a green power LED should light up.
No volume or low volume
Touch the volume "Up" (+) pad on the volume control
Input source is low
to unmute and/or increase the system volume level.
(Note:Touching the volume "Down" [-] pad lowers the
iPod/iPhone paused
system volume;touching both the [+] and
H
volume
control pads at the same time will mute the system.)
Increase the volume level on the audio source device.
Press the Play button on the iPod/iPhone or remote control.
No power; green LED Wall adapter is not plugged into Check the connection of the wall adapter.
is not on the JBL On Stage 200lD system
correctly Place the wall adapter in a known powered outlet;
test the outlet with a lamp or other device.
Wall adapter is not receiving
AC power Connect the JBL On Stage 200lD system to a known audio
source; test th.e audio source with headphones
SPECIFICATIONS
JBL ON STAGE 200lD
Frequency Response: 40Hz - 20kHz
Power Consumption: 20W maximum
Power Input: 12V/1.25A
JBL On Stage 200lD Transducer: 1 3/8" (35mm)'x 2
(full range per channel)
Dimensions: 14-1/8" x 4-5/16" x 2-1/2"
(W x D x H) (36mm x 110mm x 64mm)
Weight: 1.5 Ib (0.7kg)
WWW.JBL.COM 5