Comtech EF Data CSAT-5060 Installation And Operation Manual page 48

CSAT-5060 C-Band Transceivers
Appendix A
CSAT Remote Commands
Parameter
Type Command Arguments
TX Gain Offset UGO= 5 bytes
numerical
RX Gain Offset DGO= 5 bytes
numerical
TX Amplifier AMP= 1 byte,
value of 0,1
Mute Mode MUT= 1 byte,
value of 0,1
TX Mute UMU= 1 byte,
value of 0,1
RX Mute DMU= 1 byte,
value of 0,1
TX Slope Mode USM= 1 byte,
value of 0,1
Description of arguments
Command or Query.
TX Gain Offset for 1:1 redundancy configurations.
In dB, between -0.00 and -4.00. Resolution = 00.25 dB.
Example: UGO=-1.25
Command or Query.
RX Gain Offset for 1:1 redundancy configurations.
In dB, between -0.00 and -4.00. Resolution = 00.25 dB.
Example: DGO=-1.25
Command or Query.
TX Amplifier, where:
0 = Amplifier OFF
1 = Amplifier ON
Example: AMP=1
Command or Query.
Mute Mode, where:
0 = Unmuted after Frequency change,
1 = Muted after Frequency change.
Example: MUT=1
Command or Query.
TX Mute, where:
0 = Transmitter Unmuted,
1 = Transmitter Muted
Example: UMU=1
Command or Query.
RX Mute, where:
0 = Receiver Unmuted,
1 = Receiver Muted
Example: DMU=1
Command or Query.
TX Slope Mode, where:
0 =Manual Mode,
1 = Calibrated Mode.
Example: USM=1
A–10
Response to Response to
Command Query Query
UGO= (message ok) UGO? UGO=xx.xx
UGO? (received ok, but
See Note 1
invalid arguments found)
DGO= (message ok) DGO? DGO=xx.xx
DGO? (received ok, but See Note 1
invalid arguments found)
AMP= (message ok) AMP? AMP=x
AMP? (received ok, but See Note 1
invalid argument found)
MUT=(message ok) MUT? MUT=x
MUT?(received ok, but See Note 1
invalid argument found)
UMU=(message ok) UMU? UMU=x
UMU?(received ok, but See Note 1
invalid argument found)
DMU=(message ok) DMU? DMU=x
DMU?(received ok, but See Note 1
invalid argument found)
USM=(message ok) USM? USM=x
USM?(received ok, But See Note 1
invalid argument found)
Revision 1
MN/CSAT5060.IOM