Comtech EF Data CSAT-5060 Installation And Operation Manual page 185

C-Band Transceiver
CSAT-5060 50 Watt Installation
Step
6
7
8
9
10
11
12
13
14
15
IMPORTANT
16
17
18
19
Procedures
Attach bracket (5, figure B-1) to the strap (4) using two nuts (10), two flat
washers, (7), and two split lock washers (8).
Place the assembly against the pole with the strap around the pole and trim
strap (4) to fit as shown in Figure B-4, using tin snips or equivalent.
Attach bracket (3, figure B-1) to the strap (4) using two nuts (10), two flat
washers (7), and two split lock washers (8).
Slide tensioner bracket (2) into channel of top Unistrut (1).
Place assembly on the pole. Slide bracket (3) over bracket (2).
Place flat washer (7), splitlock washer (8), and nut (10) on bracket (2).
Tighten nut to secure the tension strap.
Slide two springnuts, (9) into channel of the Unistrut brackets (1).
Repeat procedure for second Unistrut bracket.
Install brackets (1, figure B-2) and secure to Unistrut bracket with bolts (6),
flat washers (2) and split lock washers (4).
Ensure the brackets are centered in each Unistrut. Ensure the unit is
positioned with the fan facing outward and free of any obstructions.
Do not tighten bolt (5, figure B-2) at this time.
Install four bolts (6), flat washers (2) and split lock washers (3)
on the CSAT unit.
Lift the CSAT unit and slide bolts (6) into the grooves of the brackets
(1, figure B-1).
Ensure the washers are against the bracket.
Tighten all hardware.
B–7
Revision 1
MN/CSAT5060.IOM