Dremel SM20 Operating/Safety Instructions Manual page 10

DM 2610025602 01-13_DM 2610025602 05-12.qxp 1/22/13 10:29 AM Page 10
STANDARD FLAT WHEEL ASSEMBLy
Disconnect the plug from
W RNING
the power source before
making any assembly, adjustments or
changing accessories. Such preventive safety
measures reduce the risk of starting the tool
accidentally.
The Lock Bolt which attaches the cutting wheel
to the tool should be turned CLOCKWISE to
be loosened and COUNTERCLOCKWISE to
be tightened (Fig. 3). This bolt is reverse
threaded compared to standard threaded
fasteners.
The Dremel Saw-Max features two cutting
wheel positions- one position using a standard
flat wheel for all your typical straight and
plunge cuts (Fig. 4), and a second optional
wheel position for making flush cuts along
flooring or against a wall (Fig. 5).
Do not attempt to mount
W RNING
two cutting wheels onto the
tool at the same time.
SPINDLE LOCK
INNER
W SHER
FIG. 2
ST ND RD
FL T WHEEL
FIG. 4
Assembly
1. Turn LOCK BOLT with wrench provided
2. Slide wheel behind the guard face and
3. Reinstall OUTER WASHER and tighten lock
4. Press spindle lock to lock shaft and tighten
1. Repeat step 1 of above.
2. Place flush cutting wheel against the INNER
3. Reinstall OUTER WASHER and tighten
4. Press spindle lock to lock shaft and tighten
FLUSH CUTTING
WHEEL
(OPTION L)
OUTER W SHER
GU RD
FIG. 5
F CE
ST ND RD WHEEL
-10-
clockwise and remove LOCK BOLT and
OUTER WASHER (Fig. 2). If the shaft
moves while attempting to loosen the lock
bolt press the spindle lock (Fig. 2).
mount it against the INNER WASHER on
the shaft (Fig. 4).
bolt finger tight.
LOCK BOLT counter-clockwise until tight
with the wrench provided.
FLUSH CUTTING WHEEL ASSEMBLy
WASHER on the spindle shaft. (Fig. 5).
LOCK BOLT finger tight.
LOCK BOLT counter-clockwise until tight
with the wrench provided.
GU RD F CE
LOOSEN
LOCK
BOLT
WRENCH
FIG. 3
TIGHTEN
LOCK BOLT
FLUSH
CUTTING WHEEL