Pairing The Headset And The Base Station - Sennheiser DW Series User Manual

Testing the headset system and the sound quality

Pairing the headset and the base station

Upon delivery, the headset and the base station are already paired. You
only have to pair the headset with the base station if you have purchased
the headset and base station separately or if you want to hold a
conference call.
"easy pairing" – Pairing the headset and the base station
Place the headset into the magnetic holder of the base station.
The Headset LED alternately flashes red and blue.
If pairing is successful, the Headset LED flashes 3 times blue and then
lights up continuously, indicating that the base station and the headset
are paired.
If the Headset LED flashes 3 times red and then goes off, start a new
pairing attempt by placing the headset again into the magnetic holder
of the base station.
Establishing a wireless link
Press the Link button on the headset or press the backlit button (either
PC or Phone ) on the base station. The link is established. The Link
LED on the base station lights up blue and the Headset LED flashes
blue slowly.
Disconnecting a wireless link
Press the Link button on the headset or press the backlit button (either
PC or Phone) on the base station. The link is disconnected. The Link
LED on the base station and the Headset LED go off. The headset is
in standby mode.
If your telephone has a built-in electronic hook switch supporting
the MSH standard, you can only disconnect the wireless link between
headset and base station by placing the headset into the base
station.
3x
DW Series - User Guide | 17