Troubleshooting - JVC KD-BT1 Instructions Manual

Satellite radio operations
• You can also connect the JVC SIRIUS radio PnP
(Plug and Play), using the JVC SIRIUS radio adapter,
KS-U100K (not supplied) to the CD changer jack on
the rear.
By turning on/off the power of the unit, you can turn
on/off the JVC PnP. However, you cannot control it
from this unit.
• To know more about SIRIUS Satellite radio or to sign
up, visit <http://www.sirius.com>.
• For the latest channel listings and programming
information, or to sign up for XM Satellite radio, visit
<http://www.xmradio.com>.
iPod or D. player
• When you turn on this unit, the iPod or D. player is
charged through this unit.
• While the iPod or D. player is connected, all
operations from the iPod or D. player are disabled.
Perform all operations from this unit.
• The text information may not be displayed correctly.
• If the text information includes more than 16
characters, it scrolls on the display. This unit can
display up to 40 characters.

Troubleshooting

What appears to be trouble is not always serious. Check the following points before calling a service center.
Symptom
• Sound cannot be heard from the speakers.
• The unit does not work at all.
• "Connect Error" appears on the display.
• SSM automatic presetting does not work.
• Static noise while listening to the radio.
42
Notice:
When operating an iPod or a D. player, some
operations may not be performed correctly or as
intended. In this case, visit the following JVC web
site:
For iPod users: <http://www.jvc.co.jp/english/
car/support/ks-pd100/index.html>
For D. player users: <http://www.jvc.co.jp/
english/car/support/ks-pd500/index.html>
General settings—PSM
• "Auto" setting for "Dimmer" may not work correctly
on some vehicles, particularly on those having a
control dial for dimming.
In this case, change the "Dimmer" setting to any
other than "Auto."
• If "LCD Type" is set to "Auto," the display pattern
will change to the "Positive" or "Negative" pattern
depending on the "Dimmer" setting.
• If you change the "Amp Gain" setting from
"High PWR" to "Low PWR" while the volume level is
set higher than "Volume 30," the unit automatically
changes the volume level to "Volume 30."
Remedy/Cause
• Adjust the volume to the optimum level.
• Check the cords and connections.
Reset the unit (see page 3).
Remove the control panel, wipe the connector, then attach
it again (see page 4).
Store stations manually.
Connect the antenna firmly.