Control Panel And Doors; Ovens - Rangemaster Toledo XT 110 Ceramic User's Manual & Installation Instructions

Fig.5-2
ArtNo.320-0002b
- Oven door side screws (Toledo)
Fig.5-3
appear like scratches, but can easily be removed using the
procedure described previously for 'Cleaning Spills'. If the
rub-o marks are especially stubborn, use a cleaning cream
together with the razor scraper, as described in 'Cleaning
Burned-on Spills'.

Control Panel and Doors

Avoid using any abrasive cleaners, including cream cleaners.
For best results, use a liquid detergent.
The same cleaner can also be used on the doors, alternatively,
use a soft cloth wrung out in clean hot soapy water. You can
use the same method for cleaning the control panel and
knobs.
After cleaning, polish with a dry cloth.
Glass Fronted Door Panels
The oven door front panels can be taken o so that the glass
panels can be cleaned. Move the cooker forward to gain
access to the sides (see the 'Moving the Cooker' section under
'Installation'). Open the oven door slightly and remove the
front panel xing screws from the door sides, two each side
(Fig.5-2).Carefully lift o the outer door panel. The inside
face of the glass panels can now be cleaned – take care not to
disturb or wet the door insulation.
Note: If the door is triple glazed then the inner two panels are
xed together and should not be separated.
After cleaning, carefully re t the outer door panel and replace
the side xing screws.
DO NOT use harsh abrasive cleaners or sharp metal
n n
scrapers to clean the oven door glass since they can
scratch the surface, which may result in shattering of
the glass.

Ovens

'Cook & Clean' Panels
The ovens have side 'Cook & Clean' panels which have been
coated with a special enamel that partly cleans itself. This
does not stop all marks on the lining, but helps to reduce
the amount of manual cleaning needed. These panels work
better above 200 °C. If you do most of your cooking below
this temperature, occasionally remove the panels and wipe
with a lint free cloth and hot soapy water. The panels should
then be dried and replaced and the oven heated at 200 °C for
about one hour. This will make sure the 'Cook & Clean' panels
are working e ectively.
Do not use steel wool, oven cleaning pads, or any other
materials that will scratch the surface.
16