Using The Blow Nozzle; Changing The Exhaust Direction - Hitachi NT 65M2 (S) Instruction And Safety Manual

English

USING THE BLOW NOZZLE

● Be sure to release your finger from the trigger before using the
blow nozzle.
● Do not point the air outlet of blow nozzle at a person.
● Do not use the blow nozzle with the push lever left fit.
This Nailer has a blow nozzle that blows out wood
shavings which occur during work.
Press the knob with your thumb to use the blow nozzle,
as shown in the figure.
NOTE:
● When the blow nozzle is used for a long time, the
nailing force may degrade temporarily. In this case,
allows the air supply pressure to stabilize before
starting work.
● Oil in the body or drained water from the compressor
can sometimes spout out of the air outlet of blow
nozzle. It is recommended that you once conduct a
test before use and see if such phenomenon
happens at an environment where spouted oil will
cause any inconvenience.

CHANGING THE EXHAUST DIRECTION

● When changing the exhaust direction, be sure to remove your
finger from the trigger and disconnect the air hose from the nailer.
The direction of the exhaust vent can be changed by turning the top cover.
Exhaust vent
22
WARNING
air outlet of
blow nozzle
WARNING
Top cover
Blow nozzle knob