Viking Use/Installation Guide Viking Range Corporation 111 Front Street Greenwood, Mississippi 38930 USA (662) 455-1200 For product information, call 1-888-VIKING1 (845-4641) or visit the Viking Web site at Combination Beverage Center/ vikingrange.com Ice Maker F20404C EN (070809J) 41009271 Rev C...
•Maximum amps - 3.3 (78.1 cm) •Approximate Shipping Weight - 140 lbs. (63.2 kg) To reduce the risk of fire, electrical shock, or injury when using your combination beverage center/ice maker, follow basic precautions including the following: Min. 34-1/4” •FOR YOUR SAFETY•...
GENERAL INFORMATION FULL OVERLAY PANEL INSTALLATION Unpack Note: Weight of wood panel must not exceed 20 lbs. 1. Remove banding from bottom of carton. Lift carton up and off of the unit. 2. Remove all tape and packaging material from the outside and inside of the cabinet. 3.
Page 4
SELECTING AND PREPARING THE OVERLAY PANEL ATTACHING THE OVERLAY PANEL TO THE DOOR 1. If the door is attached to the unit, remove by unscrewing the top allen head set screw at the top hinge. Remove FOR A 3-1/2” TOE KICK the door by angling the door off of the bottom hinge pin.
ELECTRICAL CONNECTION OPERATING INSTRUCTIONS General Tips and Suggestions WARNING •After making a temperature adjustment, allow at least 2 hours for your unit to reach a new temperature setting. •The motor will start and stop often. It must do this to maintain the temperature setting. ELECTRICAL SHOCK HAZARD •Unplug the unit before working on anything with the electrical system.
Spiders and insects can nest in and around the combination beverage center/ice maker causing damage to the unit. Frequently brush or vacuum lint and dirt from the condenser coils for efficient performance by unscrewing the grill on the Clean the ice maker: bottom front of cabinet.
TROUBLESHOOTING CHART TROUBLESHOOTING CHART Problem Possible Cause Solution Problem Possible Cause Solution Moisture collects on Hot and humid conditions. Extremely hot and humid conditions can cause Odor in cabinet Interior needs cleaning. Clean the interior using a solution of baking outside surface of cabinet condensation on the outside of unit.
• Name of dealer from whom purchased through the fifth year from the date of original retail purchase. Viking Range Corporation, warrantor, agrees to repair or replace, at its option, any part which fails or is found to be defective during the warranty period.
Page 9
Any sealed refrigeration system component, as listed below, is warranted to be free from defective materials or workmanship in normal household use during the third through the sixth year from the date of original retail purchase. Viking Range Corporation, warrantor, agrees to repair or replace, at its option, any part which fails or is found to be defective during the warranty period.