Messages Displayed On The Touch Panel - Toshiba E-Studio 557 Manual

1 TROUBLESHOOTING FOR THE HARDWARE

Messages Displayed on the Touch Panel

A message appears on the upper part of the screen to notify users of a problem, etc. The major examples of
problems and how to solve them are described in the table below.
Message
Close *** cover.
Misfeed in ***
Check paper size setting on
control
panel for drawer N. Check the
direction or size of the paper.
Wait (Performing Self-check)
Check the original and set it
again
Change direction of original
Change from this mode
Count over, cannot store
anymore
READY (SADDLE STITCH
TRAY FULL)
READY (CHECK SADDLE
STITCH STAPLER)
READY (CHECK SADDLE
STITCH STAPLER)
READY (CHECK STAPLER)
READY (CHECK STAPLER)
READY (HOLE PUNCH
DUST BIN IS FULL)
READY (FINISHER FULL)
READY (INNER TRAY FULL)
10

Messages Displayed on the Touch Panel

Problem Description
The cover indicated by *** is
open.
Paper misfeed has occurred
inside the equipment.
Paper misfeed has occurred
because of the mismatch
between the paper size
placed in drawer N and the
size registered for the drawer
N in the equipment.
The equipment is undergoing
maintenance to keep its
imaging quality.
The original is misfed inside of
the Reversing Automatic
Document Feeder.
The direction or the size of the
original placed on the
Reversing Automatic
Document Feeder is incorrect.
The orientation of the original
placed on the original glass is
incorrect.
The number of originals to be
scanned has exceeded the
limit specified with the
department or user code
during scanning.
The saddle stitch tray of the
finisher is full of paper.
Staple jam has occurred in the
stapler of the saddle stitch
unit.
No staples are left in the
stapler of the saddle stitch
unit.
Staple jam has occurred in the
stapler of the finisher.
No staples are left in the
stapler of the finisher.
Hole punch dust bin is full of
paper punchings.
The receiving tray of the
finisher is full of paper.
The exit tray of the equipment
is full of paper.
Corrective Action
Check the cover on the touch panel and
close it.
Remove the misfed paper following the
guidance displayed on the touch panel.
 P.14 "Clearing a Paper Misfeed"
Just removing the misfed paper does not
prevent another paper from being misfed.
Be sure to correctly register the paper size
in the equipment.
 P.30 "Clearing paper misfeeds caused
by a wrong paper size setting"
Wait until the adjustment is completed and
the message disappears.
Remove the misfed original following the
guidance on the touch panel.
 P.16 "Paper misfeed in the Reversing
Automatic Document Feeder (Lower)"
Check the direction and the size of the
original and then replace it on the
Reversing Automatic Document Feeder.
Then reattempt the operation.
Change the orientation of the original by 90
degrees and place it on the original glass.
Ask your administrator for details of setting
the limit for the number of copies.
Remove the paper from the saddle stitch
tray of the finisher.
Remove the jammed staples.
 P.38 "Staple jam in the saddle stitch
unit"
Refill the staples.
 P.50 "Refilling saddle stitch unit staples"
Remove the jammed staples.
 P.35 "Clearing a Staple Jam"
Refill the staples.
 P.47 "Refilling With Staples"
Remove the paper punchings.
 P.52 "Cleaning the Hole Punch Dust
Bin"
Remove the paper from the receiving tray
of the finisher.
Remove the paper from the exit tray of the
equipment.