Installing The Antenna; Installing The Belt Clip - Kenwood FreeTalk XL Instruction Manual

Installing the Antenna

Screw the antenna into the
connector on the top of the
Antenna
transceiver by holding the
antenna at its base and
turning it clockwise until
secure.
Note: The antenna is neither a
handle, a key ring retainer, nor a
speaker/ microphone attachment
point. Using the antenna in these
ways may damage the antenna and
degrade your transceiver's
performance.

Installing the Belt Clip

If necessary, attach the belt
clip using the two supplied
3 x 8 mm screws.
Note: If the belt clip is not installed,
its mounting location may get hot
during continuous transmission or
Belt
when left sitting in a hot environment.
clip
CAUTION: DO NOT USE GLUE
WHICH IS DESIGNED TO PREVENT
SCREW LOOSENING WHEN
INSTALLING THE BELT CLIP, AS IT
MAY CAUSE DAMAGE TO THE
TRANSCEIVER. ACRYLIC ESTER,
WHICH IS CONTAINED IN THESE
GLUES, MAY CRACK THE
TRANSCEIVER'S BACK PANEL.
4