Making A Call - Jabra SP100 User Manual

3. The green light will turn on when charging begins. After approximately 2 hours the
green light will go out indicating that the JABRA SP100 is fully charged.
4. Unplug the AC adaptor or the vehicle power charger lead from the speakerphone.
5. You are now ready to "pair" the JABRA SP100 with your mobile phone. (See Section 4)
WARNING: Using another AC adaptor other than the one provided may damage or
destroy the speakerphone. We recommend that you use the rechargeable batteries
supplied but you can use other brands. If you choose to use non-rechargeable
batteries* DO NOT use the AC adaptor or the vehicle power charger with the
JABRA SP100.
* Your JABRA SP100 can also operate with non-rechargeable 1.5-volt (AA)
Alkaline batteries.
3 Replacing the batteries
If you are using replaceable batteries, it will be necessary to periodically replace them.
1. Remove the back cover from the speakerphone and replace both batteries as
indicated. Re-attach the back cover to the speakerphone. (See Fig. 1)
4
"Pair" 2 (Connect) with your Bluetooth mobile phone
1. Turn the JABRA SP100 on.
2. Press and hold and the mute button until you see a solid blue light
(approximately 5 seconds), then release.
3. Set your Bluetooth phone to "discover" the speakerphone by following your
phone's instruction guide. Typically, the steps involve going to a "setup" , "connect" ,
or "Bluetooth" menu on your phone and then selecting the option to "discover" a
Bluetooth device*. (See example from a Sony Ericsson T610 in Fig. 3)
4
4. Your phone should find the "JABRA SP100" speakerphone and ask if you want to
pair with it. Confirm by pressing "yes" or "ok" .
5 Enter passkey or PIN
IMPORTANT: If pairing was successful, the blue indicator light will briefly flash rapidly
before going back to flashing blue every 3 seconds. If unsuccessful, the light remains
solid, and you'll need to re-attempt pairing. (See steps 3–5 above)
* Phone-specific pairing instructions can be found online at www.jabra.com/fscs
USING YOUR JABRA SP100
Before using your JABRA SP100, ensure that the batteries are charged and the JABRA
SP100 is paired with your Bluetooth mobile phone and switched on.
5

Making a call

Using your mobile phone's keypad
1. Dial number on keypad.
2. Press phone's "send" key.
Using voice-dialing (if supported by your phone)
1. Press and release
2. You'll then hear the voice-activation tone; say the name of the person you wish to call.
NOTE: Record voice tag via your mobile phone.
6
Ending a call
•
Press and release
OR
•
End call from your mobile phone's keypad.
7 Answering a call
•
After you hear the ring tone, press and release
OR
•
Answer the call with your mobile phone's keypad. You may then need to transfer the
call to the speakerphone by pressing and releasing
Fig. 3
your phone).
3 = 0000 (4 zeros), then press "yes" or "ok"
once. You'll hear 1 short beep while doing this.
once.
once.
once (depending on
5