Timeout Between Decodes - Motorola Symbol LS9208 Product Reference Manual

Timeout Between Decodes

Timeout Between Decodes, Same Symbol
This parameter sets the minimum time between decodes of different symbols. It is programmable in 0.1-second
increments from 0.0 to 9.9 seconds. Motorola recommends setting this above 0.4 seconds. The default is 0.6
seconds.
Scan the bar code below to select a new timeout. Next, scan two numeric bar codes from
Codes that correspond to the desired timeout. Include a leading zero for single digit numbers. For example, to set
a timeout of 0.5 seconds, scan the bar code below, then scan the 0 and 5 bar codes. To correct an error or change
a selection, scan Cancel on
Timeout Between Decodes, Different Symbol
This parameter sets the minimum time between decodes of different symbols. It is programmable in 0.1-second
increments from 0.0 to 9.9 seconds. The default is 0.2 seconds.
Scan the bar code below to select a new timeout. Next, scan two numeric bar codes from
Codes that correspond to the desired timeout. Include a leading zero for single digit numbers. For example, to set
a timeout of 0.5 seconds, scan the bar code below, then scan the 0 and 5 bar codes. To correct an error or change
a selection, scan Cancel on
page D-4.
Timeout Between Same Symbol
page D-4.
Timeout Between Different Symbol
User Preferences 4 - 11
Appendix D, Numeric Bar
Appendix D, Numeric Bar