Page Mode (2-Way Remote Only); Remote Pairing - Clifford 3806X Owner's Manual

Page Mode (2-way remote only)

Options: Power Save 1, Power Save 2, On, Off
Paging is how the Responder LE remote monitors your system's mes-
sages. Power Save extends battery life by turning Paging Off after
one week if the remote control is not used during this period. Just press
any button to resume system monitoring. Power Save 2 is for maximum
battery life and will monitor the system only when remote start has
been activated.
Caution: Alarm trigger messages will not be received when remote
start is off. When set to On it wakes up every few seconds to listen for
pages from the system. When set to Off it does not wake up to receive
remote start or alarm trigger pages.
Note: When Off, responses are still received when a command is
performed but alarm trigger pages will not be received.

Remote Pairing

The following instructions steps you through remote control pairing to
your system for both the 1-way and 2-way remote controls.
Note: Both the remote and the vehicle need to be prepared to pair
a remote to the system.
Prepare the remote for pairing:
1. Press and hold the
turn on, release the
2. Within 30 seconds press and hold the
seconds, the transmit LED flashes then comes on, release the
button
3. The remote is now ready for pairing.
18
button for 8 seconds, the transmit LED will
button.
button for two
© 2014 Directed. All rights reserved.