Door Mounting Instructions - Dometic RM2351 Installation & Operating Instructions Manual

DOOR MOUNTING INSTRUCTIONS

REVERSING THE DOOR SWING
For all models, except NDR1292, the refrigerators are equipped
with hinges that makes it possible to change the direction the
door opens by moving the hinges to the opposite side. A special
hinge kit must be used in order to change the door swing.
For conversion kit number, see
For additional information, please contact service point or
distributor service dept. for assistance.
MOUNTING THE DOOR PANEL(S)
Optional door insert panels are available for all
models except NDR1292. The refrigerator is normal-
ly delivered without door panel(s).
Before starting the mounting work, read this instruction thor-
oughly and check that the panel dimensions are in compliance
with those given in the following table:
PANEL DIMENSIONS
max. thickness 5/32" (4 mm)
max
UPPER
403
mm
15-27/32 15-25/32 20-3/4
inch
LOWER /SINGLE
DOOR
RM2351
667
mm
RM2354
26-17/64 26-3/16 19-5/8
inch
RM2451
827
mm
RM2454
DM2652
DM2662
32-9/16 32-1/2
inch
DM2663
RM2551
983
mm
RM2554
DM2852
DM2862
38-11/16 38-5/8
inch
NDM1062
FROZEN FOOD
COMPARTMENT
NDR1292 1402
mm
55-3/16 55-1/8
inch
FRESH FOOD COMPARTMENT
NDR1292 1402
mm
55-3/16 55-1/8
inch
.
APPENDIX A - SPARE PARTS
Height Width
min max min
401 527 524
20-5/8
665 498 496
19-17/32
825 527 524
20-3/4 20-5/8
981 527 524
20-3/4 20-5/8
1400 288 265
10-9/16 10-7/16
1400 430 427
16-15/16 16-13/16
With screws
To mount the panel, follow these steps:
1. Open the door 90 degrees.
2. On new refrigerators, the decoration strip is taped
inside the door; if installed on the door, remove
the door decoration strip (2) by removing its three
screws (1).
NDR1292:
Fresh food compartment door - remove three screws.
Freezer compartment door - remove two screws.
3. Insert the vertical edges into the grooves of the door
frame (3).
4. Push the panel downwards so that the lower
horizontal edge of the panel (4) is fi tted into the bot-
tom grove (5).
5. Put the decoration strip across the door so that the
gap is covered. Secure the decoration strip with the
screws removed in step 2.
1
1
2
1
1
- 10 -
1
1
3
4
5
3