Door Mounting Instructions - Dometic RM2554 Installation & Operating Instructions Manual

door mounting instructions

reVerSing the door Swing
For all models, except NDR1292, the refrigerators are equipped
with hinges that makes it possible to change the direction the
door opens by moving the hinges to the opposite side. A special
hinge kit must be used in order to change the door swing.
For conversion kit number, see
For additional information, please contact service point or
distributor service dept. for assistance.
Mounting the door Panel(S)
Optional door insert panels are available for all
models except NDR1292. The refrigerator is normal-
ly delivered without door panel(s).
Before starting the mounting work, read this instruction thor-
oughly and check that the panel dimensions are in compliance
with those given in the following table:
paNel DiMeNsioNs
max. thickness 5/32" (4 mm)
UPPER
403
mm
15-27/32 15-25/32 20-3/4
inch
LOWER /SINGLE
DOOR
RM2351
667
mm
RM2354
26-17/64 26-3/16 19-5/8
inch
RM2451
827
mm
RM2454
DM2652
DM2662
32-9/16 32-1/2
inch
DM2663
RM2551
983
mm
RM2554
DM2852
DM2862
38-11/16 38-5/8
inch
NDM1062
FRoZEN FooD
CoMPARTMENT
NDR1292 1402
mm
55-3/16 55-1/8
inch
FRESh FooD CoMPARTMENT
NDR1292 1402
mm
55-3/16 55-1/8
inch
APPENDIx A - SPARE PARTS
height width
max min max
401 527
665 498
825 527
20-3/4
981 527
20-3/4
1400 288
10-9/16 10-7/16
1400 430
16-15/16 16-13/16
with screws
To mount the panel, follow these steps:
1. Open the door 90 degrees.
2. On new refrigerators, the decoration strip is taped
inside the door; if installed on the door, remove
.
the door decoration strip (2) by removing its three
screws (1).
NDR1292:
Fresh food compartment door - remove three screws.
Freezer compartment door - remove two screws.
3. Insert the vertical edges into the grooves of the door
frame (3).
4. Push the panel downwards so that the lower
horizontal edge of the panel (4) is fitted into the bot-
tom grove (5).
5. Put the decoration strip across the door so that the
gap is covered. Secure the decoration strip with the
screws removed in step 2.
min
524
20-5/8
1
2
496
19-17/32
1
524
20-5/8
524
20-5/8
265
427
- 11 -
1
1
1
1
3
3
4
5