Mounting Instructions; Removing And Replacing The Shelves - Dometic RM4605 Installation & Operating Instructions Manual

Cross-sections
The wires connected to this terminal must have a mini-
mum cross-section area of 1.5 mm
D+ connection
The connection D+ (alternator) has to be connected to the
corresponding outlet of the vehicles electrical system - ei-
ther a 12V or 24V DC alternator. The D+ connection ac-
cepts 24V. Please note that the refrigerator accepts 12V
only.
Do not connect the refrigerator to 24V!
This connection provides a signal to the refrigerators AES
control system informing the control system when the ve-
hicle engine is running.
The AES refrigerator can not select 12V as the energy
source unless the vehicle engine is running.
Cross-sections
The D+ (alternator) is a signal cable and therefore 1-1.5
mm is sufficient.
2

MOUNTING INSTRUCTIONS

REPOSITIONING THE HINGES
The refrigerator is equipped with reversible doors. A spe-
cial door reversing kit must be used to reverse the doors.
For further information, please contact your dealer.
.
2
REMOVING AND REPLACING THE
SHELVES
1. Remove the shelf locks by inserting the tip of
a flat bladed screwdriver into the slot of the
locks. Turn the screwdriver counterclockwise
and then remove the shelf locks from the wire
shelf.
2. Tilt the shelf to one side at an angle while pull-
ing forward.
3. Reposition the shelf in the desired location.
Insert the ends of the wire shelf on the left-
hand side and slide the shelf into the holes on
the right-hand side.
4. Slide the plastic plugs into the holes of the
wall.
5. Snap the shelf locks onto the wire shelf.
14