Entering Login And Internet Connection Information - Cisco RV 120W Administration Manual

Introduction
Connecting the Equipment
STEP 1
STEP 2
STEP 3
STEP 4
Cisco RV 120W Administration Guide

Entering Login and Internet Connection Information

Enter the username and password for your Cisco RV 120W. The default username
and password are both admin. Click Next.
Choose your Internet connection type:
• Telephone (DSL)
• Cable broadband
• I don't know
Click Next.
The Setup Wizard confirms your Internet connection settings. If it cannot detect or
confirm your settings, you might need to provide information about your Internet
connection type. You can get this information from your ISP.
The types of Internet connections are:
• Dynamic (DHCP)—Your PC receives its IP address from your cable or DSL
modem. This address can change.
• Static IP Connection—Your Internet Service Provider (ISP) has assigned
you an IP address that does not change. You will need this address and
some additional information (see Step 4) to proceed with installation.
• PPPoE—You have a point-to-point connection to the Internet (used mainly
with asymmetric DSL).
• PPTP—Your provider uses point-to-point tunneling protocol (used in
Europe).
• LT2P—Your provider uses layer 2 tunneling protocol (used in Europe).
After selecting your connection type, click Next.
If you chose:
• Dynamic (DHCP)—Proceed to Step 5.
• Static IP Connection—Provide your Static IP Address, Subnet Mask,
Gateway IP, DNS, and secondary DNS (optional). This information comes
from your ISP. Click Next after entering the information.
• PPPoE—Provide your account name (for example,
password. Click Next after entering the information.
1
john@ISPname.net
), and
13