Adding Snmp Traps; Configuring Access Control Rules - Cisco RV 120W Administration Manual

Administering Your Cisco RV 120W
Configuring Simple Network Management (SNMP)
STEP 3
STEP 4
STEP 1
STEP 2
STEP 3
STEP 4
STEP 5
STEP 6
Cisco RV 120W Administration Guide
• NoAuthNoPriv—Doesn't require any Authentication and Privacy.
• AuthNoPriv—Submit only Authentication algorithm and password.
• AuthPriv—Submit Authentication/privacy algorithm and password.
If you chose AuthNoPriv or AuthPriv, choose the type of authentication algorithm
(MD5 or SHA) and enter the authentication password.
If you chose AuthPriv, choose the type of privacy algorithm (DES or AES) and enter
the privacy password.
Click Save.

Adding SNMP Traps

The Traps List Table lists IP addresses of SNMP agents to which the router will
send trap messages (notifications) and allows several operations on the SNMP
agents.
To add a new trap:
In the Traps List Table, click Add.
Enter the IP Address of the SNMP manager or trap agent.
Enter the SNMP trap port of the IP address to which the trap messages will be
sent.
Enter the community string to which the agent belongs. Most agents are
configured to listen for traps in the Public community.
Choose the SNMP Version: v1, v2c, or v3.
Click Save.

Configuring Access Control Rules

The SNMP Access Control List is a table of access rules that enables read-only or
read-write access for select IP addresses in a defined SNMP agent's community.
7
129