MX12 Re ceiver
Installation (MX12 receiver)
By following these instructions, the left-hand row of
pushbuttons on the
Projector 1, and the right-hand row of pushbuttons will
control Projector 2.
1. Plug the
receiver remote control cable (A) marked
MX
Remote 1 into the remote receptacle (B) on Projector 1.
2. Plug the
power cord (G) for Projector 1 into the
AC
left
outlet on the rear of the
AC
3. Plug the
receiver remote control cable (F) marked
MX
Remote 2 into the remote receptacle (B) on Projector 2.
4. Plug the
power cord (E) for Projector 2 into the
AC
right
outlet on the rear of the
AC
5. Plug the
receiver power cord (C) into a standard
MX
wall outlet.
6. Extend the black antenna wire vertically.
7. Set the lamp switch on the projector (D) to either the
or
position.
HIGH
LOW
12
transmitter will control
MX12
receiver.
MX
receiver.
MX
Figure 12
Installation of
receivers
MX12