Receivers - AMX MX Series Instruction Manual

Installation (MX3, MX4A receivers)
Figure 8 shows an illustration of the installation of
and receivers. To install
MX3 MX4A

receivers:

1. Plug the 5-pin receiver cord (A) into the remote
receptacle on the projector (B).
2. Plug the projector
AC
outlet on the rear of the
3. Plug the receiver power cord (C) into a standard
MX
wall outlet.
4. Extend the black antenna wire vertically.
5. Set the lamp switch on the projector (D) to either the
or position.
HIGH LOW
MX3(L), MX4A(L) Re ceivers
and
MX3 MX4A
power cord (E) into the AC
receiver unit.
MX
Figure 8
Installation of
MX3
and receivers
MX4A
9