Remote Set-Up; Verify The Switch Is On "Remote; Synchronize The Transmitter To The Ifc; Clearing The System Memory - Travis Industries 616 Diamond-Fyre GSR2 Owner's Manual

32

Remote Set-Up

Verify the Switch is on "REMOTE"

The battery holder has a switch built into it (see Figure 1). This switch must remain in the REMOTE
position for the remote to operate.

Synchronize the Transmitter to the IFC

The transmitter will need to be synchronized to the IFC (Integrated Fireplace Control) before the remote
will work correctly. Synchronizing is done in the following two steps below (see Figure 2):
1. Press the PRG (Program) button on the battery box (IFC will beep 3 times).
2. Press the "ON" button on the transmitter (IFC will beep 3 times).
NOTE: If power is cut off to the IFC for an extended period of time, you may need to re-synchronize the
remote.

Clearing the System Memory

This appliance uses an Integrated Fireplace Control (IFC) to store the unique code for the remote control.
If you wish to clear the system memory, MAKE SURE GAS IS TURNED OFF TO THE APPLIANCE then
press the PRG (Program) button for 10 seconds. The pilot will start to spark repeatedly, signifying all
system memory has been cleared. The system will return to its original configuration  a remote will need
to be synchronized; and the system will operate in Continuous Pilot mode.
© Travis Industries
Operation
"Beep"
"Beep"
"Beep"
4140811
Figure 1
Figure 2
"Beep"
"Beep"
"Beep"
100-01331