Stage 2: Installing The Ff 120 Speakers; Stage 3: Installing The Polevault Switcher; Stage 4: Connecting The Cables; Stage 5: Setting Up The Microphone And Testing The System - Extron electronics VoiceLift User Manual

Stage 2: Installing the FF 120 Speakers

1. Remove the ceiling tiles where the speakers will be installed.
2.
Mark a line 12 inches (30 cm) from and parallel to one of the short edges of the ceiling
tile and cut the tile.
3. Lay a T-rail (supplied) 12 inches (30 cm) from one end of the ceiling T-frame.
4.
Remove the terminal cover from the rear of one speaker and attach the anchor ring
and cable clamp to the cover.
5. Place the speaker onto the T-frame and pass the speaker cable through the cable
clamp.
6. Connect the speaker wires to the speaker terminals.
7.
Reattach the terminal cover and bend the seismic tabs over the T-rail.
8.
Replace the ceiling tile.
9. Repeat steps 1 through 8 for each speaker to be installed.
10.
Terminate the speaker cable for the PVS switcher.

Stage 3: Installing the PoleVault Switcher

See the instructions in the PoleVault System Installation Guide to install the switcher.

Stage 4: Connecting the Cables

1.
Pull the Ethernet communication cable, and any other cables that will be attached, to
the receiver location.
2.
Connect the Ethernet cable to the RJ-45 jack labeled Out, on the receiver base.
3.
Connect cables for any additional devices to the receiver (for example, an MLC cable to
the Rly port, a secondary receiver to the RJ-45 In jack, and so on).
4.
Align the arrow on the dome tab with the arrow on the edge of the housing and
attach the dome to the receiver.
5.
Pull the cables from the receiver to the PoleVault switcher location.
6.
Connect the other end of the Ethernet cable to the PoleVault switcher (for the
VLR 102) or to the RJ-45 In jack (for the VLR 102SR secondary receiver).

Stage 5: Setting Up the Microphone and Testing the System

1. Configure the PoleVault system (refer to the PoleVault Systems Installation Guide, part
number 68-1390-01).
2. Set up the microphone (set the channels, apply the label, insert the battery, and attach
the lanyard).
3.
Test the system: power on all devices and test the microphone audio.
VoiceLift System • Installing the Receiver (Overview) 42