Installing The Vlc 302 Charger And Charging The Microphones - Extron electronics VoiceLift Pro Microphone EB Kit Series User Manual

Table of Contents

Advertisement

Installing the VLC 302 Charger and Charging the Microphones

The VLC 302 charges the microphone battery. It is powered by an external wall power
supply (provided). The microphone battery requires up to 5 hours to charge fully. It is safe
to charge for extended periods, but Extron recommends storing the microphone out of the
charger with the battery removed.
NOTES:
Follow these steps to connect the charger and
charge the microphones.
1.
2.
3.
CAUTION:
ATTENTION : Utilisez uniquement les piles rechargeables de type NiMH fournies par
ATTENTION:
ATTENTION:
The charging station is to be used with NiMH rechargeable batteries only.
Fully charge the supplied batteries before first use.
Connect the 5 VDC, 2.6 A wall charger to
a 110-130 VAC (U.S.) or a 100-240 VAC
(international), 50-60 Hz power source
(see
at right).
1
Connect the USB mini plug end of the adapter
to the USB mini jack located on the back of the
VLC 302 (
).
2
To install the battery, remove the microphone battery
cover as follows:
VLP 302: Unscrew the two rear panel screws
located on either side of the rear clip.
VLH 302: Slide the battery cover downward
until it stops, then lift the cover up and off the
microphone.
Insert the battery, aligning the + and – poles as
indicated inside the compartment.
Use only NiMH rechargeable batteries provided by Extron when charging
the microphone. Use of any rechargeable battery other than the type provided by
Extron may cause explosion, chemical leakage, and injury.
Extron, lorsque vous rechargez le microphone. L'utilisation d'une pile rechargeable
différente du type fourni par Extron peut présenter un risque d'explosion, de fuite de
substances chimiques, ou de blessure.
Be sure to replace the battery with the correct type and to dispose of
used batteries appropriately.
Assurez vous de remplacer les piles par le bon modèle et de jeter les
piles usagées de façon appropriée.
VoiceLift Pro Microphone EB Kits User Guide • VLME Kit Installation and Operation
1 1
LED
_
+
4 4
VLP 302
(Cover Removed)
2 2
+
VLH 302
(Cover Removed)
9

Advertisement

Table of Contents
loading

Table of Contents