Switching The Server Blade On And Off - Fujitsu PRIMERGY BX620 S6 Operating Manual

Switching the server blade on and off

5.2 Switching the server blade on and off
V
CAUTION!
If you switch the server blade on and just flickering stripes appear on the
connected monitor, switch the server blade off again immediately (see
the chapter "Troubleshooting and tips" on page
This section describes how to switch the BX620 S6 Server Blade on and off
using the control panel when the basic unit is switched on.
The basic unit also allows you to switch the installed server blades on and off
using the control panel of the entire system as well as using the Web interface
of the management blade. You will find more detailed information on this in the
"PRIMERGY BX600 S3 Basic Unit" manual.
Switching the server blade on and off using the control panel
The basic unit must be switched on.
The server blade can be switched on and off as follows:
– To switch the server blade on, hold down the On/Off button on the server
blade (item 2 in
To switch the server blade off, hold down the On/Off button on the
server blade (item 2 in
– Set switch-on/off time
The server blade is switched on and off at the times defined in the
ServerView Operation Manager.
– After power failure
Once a server blade has been switched on, it will switch itself on again
automatically after a power failure (depending on the BIOS settings, see
chapter "BIOS Setup" on page
48
figure 7 on page 44).
figure 7 on page
53).
Operating Manual
85).
44) for 4 seconds.
BX620 S6