Sony XDCA-53 Operating Instructions Manual page 13

3
Peel off the covers from the double-
sided tapes on the rear side of the
supplied plate, and attach the plate to
the VCT-SP2BP.
Double-sided tapes
Plate
VCT-SP2BP
4
Place the camcorder on a flat surface
with the bottom panel facing up, and
insert the spacer into the tripod screw
holes.
Bracket
5
Place the VCT-SP2BP on the bottom
panel of the camcorder, with the rear
side facing up. Secure the VCT-SP2BP
by tightening screws into the tripod
screw holes of the camcorder.
The VCT-SP2BP cannot be attached if
your camcorder has only one tripod
screw hole.
For details, contact your dealer or a Sony
service representative.
Spacer
Tripod screw holes
VCT-SP2BP
Camcorder
Tripod screw holes
System Configuration 13