Ep65 Optional Blower Installation; Ep90-K Optional Screen Kit - Napoleon 1600C-1 Installation And Operating Instructions Manual

6.2

EP65 OPTIONAL BLOWER INSTALLATION

USE ONLY WOLF STEEL APPROVED ACCESSORIES AND REPLACEMENT PARTS WITH THIS APPLI-
ANCE. USING NON-LISTED ACCESSORIES (BLOWERS, DOORS, LOUVRES, TRIMS, GAS COMPO-
NENTS, VENTING COMPONENTS, ETC.) COULD RESULT IN A SAFETY HAZARD AND WILL VOID THE
ENSURE THAT THE FAN'S POWER CORD IS NOT IN CONTACT WITH ANY SURFACE OF THE AP-
PLIANCE TO PREVENT ELECTRICAL SHOCK OR FIRE DAMAGE. DO NOT RUN THE POWER CORD
ALL WIRING SHOULD BE DONE BY A QUALIFIED ELECTRICIAN AND SHALL BE IN COMPLIANCE
WITH LOCAL CODES. IN THE ABSENCE OF LOCAL CODES, USE THE CURRENT CSA22.1 CANADIAN
ELECTRIC CODE IN CANADA OR THE CURRENT NATIONAL ELECTRIC CODE ANSI/NFPA NO. 70 IN
A. Ensure the thermal disc bracket is in the correct position.
B. Install the blower and housing as shown using the 4 screws supplied.
C. Loosen the thermal disc bracket (2 screws) and slide the bracket until the
thermal disc is touching the heat shield and secure.
THERMAL DISC BRACKET
Check that the thermal disc
bracket is positioned
as illustrated.
6.3

EP90-K OPTIONAL SCREEN KIT

NEVER LEAVE APPLIANCE OPERATING UNSUPERVISED WITH SPARK SCREEN IN PLACE.
USE CAUTION WHEN PLACING THIS SPARK SCREEN ON AN OPERATING APPLIANCE.
TURN OFF THE BLOWER BEFORE OPERATING WITH THE SPARK SCREEN.
USE ONLY WOLF STEEL APPROVED OPTIONAL ACCESSORIES AND REPLACEMENT PARTS WITH
THIS APPLIANCE. USING NON-LISTED ACCESSORIES AND REPLACEMENT PARTS (BLOWERS,
DOORS, LOUVRES, TRIMS, GAS COMPONENTS, VENT COMPONENTS, ETC.) COULD RESULT IN A
The 1600C-1 may only be operated with the doors open when spark screen
EP90-K is used and installed properly.
This kit is not applicable for mobile homes.
WARRANTY AND CERTIFICATION.
BENEATH THE APPLIANCE.
SAFETY HAZARD AND WILL VOID THE LIMITED LIFETIME WARRANTY.
WARNING
!
RISK OF FIRE
THE UNITED STATES.
WARNING
!
19
SCREWS
B L
O W
E R
2
THERMAL
DISC BRACKET
3
W415-0721 / B / 05.03.11