Chapter 1. General Description; Specifications - Sharp UX-40 Service Manual

CHAPTER 1. GENERAL DESCRIPTION

[1] Specifications

Automatic dialing:
Fax(thermal) paper:
Modem speed:
Transmission time* :
Resolution:
Automatic document feeder: 5 pages max. (80 g/cm
Halftone (grayscale):
Display:
Compression scheme:
Applicable telephone line:
Compatibility:
Input document size:
As a part of our policy of continuous improvement, SHARP reserves the right to make design and specification changes for procduct
improvement without prior notice. The performance specifications figures indicated are nominal values of production units. There may be some
deviation from these values in individual units.
Rapid Key Dialing: 5 numbers
Speed Dialing: 35 numbers
Initial starter roll (included with machine):
10 m
Recommended replacement roll:
FO-20PR, 30m
9600 bps with automatic fallback to lower
speeds
Approx. 15 seconds
Horizontal: 8 dots/mm
Vertical:
Standard: 3.85 lines/mm
Fine/Halftone: 7.7 lines/mm
Super fine: 15.4 lines/mm
2 paper)
64 levels
16-digit LCD display
MR, MH, Sharp (H2)
Public switched telephone network/PBX
ITU-T (CCITT) G3 mode
Automatic feeding:
Width: 148 to 216 mm
Length: 140 to 297 mm
Manual feeding:
Width: 148 to 216 mm
Length: 140 to 600 mm
Effective scanning width:
Effective printing width:
Contrast control:
Reception modes:
Copy function:
Noise emission:
Telephone function:
Power requirements:
Operating temperature:
Humidity:
Power consumption:
Dimensions:
Weight:
* Based on ITU-T (CCITT) Test Chart #1 at standard resolution in Sharp
special mode, excluding time for protocol signals (i.e., ITU-T phase C
time only).
Note: The facsimile machine is Year 2000 compliant.
1 – 1
UX-40DE
FO-50DE
210 mm max.
210 mm max.
Automatic/Dark selectable
Fax, Tel, Fax/Tel
Yes
Less than 70 dBA (Measured accord-
ing to DIN 45 635)
Yes (cannot be used if power fails)
220-230 V AC, 50 Hz
5 - 35°C
Maximum: 85 % RH
Standby: 2.3 W
Maximum: 115 W
Width: 304 mm
Depth: 236 mm
Height: 122 mm
Approx. 2.6 kg