Chapter 1. General Description; Specifications - Sharp UX-177 Service Manual

CHAPTER 1. GENERAL DESCRIPTION

[1] Specifications

Applicable telephone line:
Compatibility:
Configuration:
Compression scheme:
Scanning method:
Resolution:
Recording system:
Display:
Reception modes:
Modem speed:
Transmission time* :
Effective recording width:
Input document size:
As a part of our policy of continuous improvement, SHARP reserves the right to make design and specification changes for procduct
improvement without prior notice. The performance specifications figures indicated are nominal values of production units. There may be some
deviation from these values in individual units.
Public switched telephone network
ITU-T (CCITT) G3 mode
Half-duplex, desktop transceiver
Modified Huffman and Sharp special
mode
Flat-bed, solid-state CCD
Horizontal:
8 dot/mm
Vertical:
Standard
Fine/Halftone−7.7 lines/mm
Super fine−15.4 lines/mm
Thermal recording
7 x 5 dots, 1 line by 16-digit display
FAX/TEL/TEL-FAX/A.M.
9600 bps with automatic fallback to
7200, 4800, or 2400 bps
Approx. 15 seconds
(Sharp special mode)
210 mm, max.
Automatic feeding:
Width  148 to 216 mm
Length  128 to 297 mm
Manual feeding:
Width  148 to 216 mm
Length  128 to 1000 mm
Effective scanning width:
Automatic document feeder: 20 sheets max.
Halftone (gray scale):
Contrast control:
Copy function:
Telephone function:
Noise emission:
Power requirements:
Operating temperature:
Power consumption:
Dimensions:
Weight:
* Based on ITU-T (CCITT) Test Chart #1 at standard resolution in
Sharp special mode, excluding time for protocol signals (i.e.,
ITU-T phase C time only).
1 – 1
UX-177H
210 mm
64 levels
Automatic/Dark selectable
Standard
Standard
(cannot be used if power fails)
Less than 70 dBA
(Measured according to DIN 45635.)
230 V AC, 50 Hz
5 to 35°C
Stand-by: 8 W
Maximum: 120 W
Width: 341 mm
Depth: 257 mm
Height: 123 mm
2.9kg