JVC MX-GB6 Service Manual page 16

3.1.9 Removing the main board
(See Figs.26 to 28)
• Prior to performing the following procedures, remove the top
cabinet, CD changer mechanism assembly and amplifier
board.
(1) From the forward side of the main board, disconnect the
card wires from the connectors (CW101, CW102). (See
Fig.26.)
(2) Disconnect the wires from the connectors (CW01A,
CW108, CW109, CW111, CW112) on the main board.
(See Fig.26.)
(3) Disconnect the wire from the connector
er supply board. (See Fig.26.)
(4) From the left side of the main body, remove the screw T at-
taching the main board. (See Fig.27.)
(5) From the top side of the main body, remove the two screws
U attaching the main board. (See Fig.28.)
(6) Take out the main board from the main body.
Reference:
Insert the main board in the slot e before attaching the main
board to the bottom chassis. (See Fig.28.)
3.1.10 Removing the power supply board
(See Figs.26 and 28)
• Prior to performing the following procedures, remove the top
cabinet, CD changer mechanism assembly and amplifier
board.
(1) From the forward side of the power supply board, discon-
nect the wire from the connector PCW1. (See Fig.26.)
(2) Disconnect the power cord from the connector
the power supply board. (See Fig.28.)
(3) From the top side of the main body, remove the four screws
V attaching the power supply board. (See Fig.28.)
(4) Take out the power supply board from the main body.
1-16 (No.MB160)
Card wire
CW109
PCW1 on the pow-
Wires
PW101 on
Power cord
PW101
CW101
Wires
CW01A CW112
CW108
Power supply board
Fig.26
Main board
Fig.27
V
V
e
U
Fig.28
Main board
Card wire
CW102
Wires
PCW1
CW111
T
Power supply board
Main board