Using The Zip Drive In Windows 95/98 Dos Mode - Iomega 3798300 Owner's Manual

You want to use Windows 95/98 DOS mode with your Zip
NOTE:
MS-DOS mode which is a start option for Windows 95/98. It does not
apply to the DOS box (or window) that opens when you double click
the MS-DOS Prompt
box with the Zip
drive under Windows 95/98.
In order for the Zip
mode, you must perform a clean reboot when switching to or from DOS
mode. Do not use the option from the Windows 95/98 Shut Down menu
that reads: "Restart the computer in MS-DOS mode." This option does
not fully support the Zip drive.
To switch to DOS mode:
(1) Restart the computer and press F8 just before the full-color
Windows logo screen loads. (If you are using Windows 95, look
for the text line "Starting Windows 95" to appear on the screen. If
you are using Windows 98, watch for a black screen with a
blinking cursor.)
(2) When the menu appears, select "Command Prompt Only."
(3) After the system boots into DOS mode, run guest.exe from the
directory containing your IomegaWare
the default directory for a new software installation, the command line
is:
This procedure will provide access to any Iomega drives on the system.
To return to the Windows 95/98 graphical interface again, restart the
computer.
IMPORTANT!
running GUEST.EXE as this will cause duplicate drive letters.
This section describes how to switch in and out of the
icon within Windows 95/98. Use of the DOS
® drive works the same as it does with any other
®
drive to operate properly in Windows 95/98 DOS
c:\progra~1\iomega\tools\guest.exe
Do NOT type "WIN" at the DOS prompt after
TM
software. If you have used
® drive.
43