Getting Started - Iomega 3798300 Owner's Manual

Getting Started

IMPORTANT!
onboard IDE/ATA interface. See the
Understanding IDE Connections
for important information.
1
Check system requirements.
• Pentium 100 MHz or higher IBM-compatible computer
• Empty 3
• Embedded IDE interface or IDE controller card
• Windows NT
• Iomega software (included with the Zip
NOTE: The Zip
specifications; however, some computers with early ATAPI support
do not meet these specifications and may not work correctly with
removable ATAPI drives like the Zip Internal drive. If the computer
fails to boot correctly or hangs while booting after the Zip Internal
drive is installed, refer to page 40 in the
of this guide.
2
Unpack the Zip
CAUTION
metal object (like an unpainted metal screw on the back of your
computer) to discharge any buildup of personal static electricity.
IomegaWare™ CD
Owner's Manual CD
Owner's Manual
IDE Data
Cable
Power-Y Cable
Zip Internal Drive
250MB Zip Disk
Drive Bay Mounting Screws
Jumper
IMPORTANT!
always needed for proper installation.
4
The Zip Internal drive uses the computer's
1 ⁄ or 5 1 ⁄ " drive bay with front panel access
2 " 4
® ®
, Windows
® Internal drive meets the latest ATAPI
® Internal ATAPI drive.
Before handling the Zip
The jumper that shipped with your Zip drive is not
User's Guide
on pages 36 and 37 of this guide
95/98, or Windows 3.1
® Internal drive)
Troubleshooting
®
Internal drive, touch a grounded
section
section